Model #831299202 PROFORM Treadmill

  • Treadmill
    3 Results
Find part by diagram >

Question and Answers

Q:

i can't keep my walking belt centered on my pro-form t35.

A:

I am sorry that you are having some difficulties with the belt on your treadmill and I will be happy to help. I did some research and I was able to find a link with a similar question. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
February 23, 2013
A:

I recommend that you adjust the belt until the belt is tension is correct as shown on page 13 of your owner's manual. Here is a link for that manual in case you need it: ProForm T35 Treadmill Model 831.299202 Owner's Manual. The point at which you have proper tension on the belt is where you should begin when eliminating movement.

 

Once you have the tension adjusted properly, then you should be able to move the roller to eliminate belt movement as shown on that same page in the manual. I see that Joseph P. posted a link for a previous answer in the above response. That previous answer has a video that illustrates that procedure. 

 

I hope that this information helps. If you need more assistance, reply with additional details. 

Read More
Lyle W -
Sears Technician
February 25, 2013
See more answers
Q:

Treadmill malfunctioning

A:

Manage My Life is a great website to speak directly to an expert who can help you every step of the way to solving the problem you are having. An expert shall have an answer to your question within 24 to 48 hours. Have a great day.

Read More
Alina F. -
September 11, 2011
A:

Thank you for your question.

I am sorry you are having a problem with the treadmill. A few things that would cause the speed change. I recommend feeling the underside of the walking belt with your hand. If the belt feels fuzzy, the belt is dragging. To cure this you will need to replace the belt. If the belt feels fine, feel the walking board. The board should be greasy feeling if it is not the belt should be lubed. To correct this problem apply some deck wax, NOT Silicone, to the walking board. There is a lube kit available as well as a single tube. Both come with installation instructions, the part number for a single tube of wax is 219168 for $3.99, the part number for the kit which includes 3 tubes of wax, an application wand and a case is 219170 for $29.99 and they are available at Sears Parts Direct .

Just in case the lube does not come with instructions, I will add them. Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply 1/2 the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

If the console will not light up when the batteries the console is defective. I looked up the console to get you the part number but it is no longer available to order. If the read out does not matter to you, you can use the treadmill without it.

I hope this is helpful.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
September 13, 2011
See more answers

Top Parts