Model #831297364 PROFORM Treadmill

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I replace the belt on my treadmill?

A:

The instructions for replacing the belt on a treadmill have never been printed. There are so many models with different variations it would be very difficult to do. Technicians are taught the basics at training sessions and are expected to adapt to the model they are working on.

Basically you disconnect the power to the treadmill and remove the motor hood. Remove the drive belt from the motor and front roller.

Remove the side rails and the rear end caps. Remove the walking board.

Remove the adjusting bolts for the rear roller and remove both front and rear rollers.

Slide the walking belt off the right side of the rollers.

Reverse these instructions for installation of new belt.

Read More
Landell -
Sears Technician
February 16, 2010
Q:

We bought a replacement walking belt for our Proform model 831297364. Need detailed steps to replace the belt. Can you help?

A:

The instructions for replacing the belt on a treadmill have never been printed. There are so many models with different variations it would be very difficult to do. Technicians are taught the basics at training sessions and are expected to adapt to the model they are working on.

Basically you disconnect the power to the treadmill and remove the motor hood. Remove the drive belt from the motor and front roller.

Remove the side rails and the rear end caps. Remove the walking board.

Remove the adjusting bolts for the rear roller and remove both front and rear rollers.

Slide the walking belt off the right side of the rollers.

Reverse these instructions for installation of new belt.

Read More
Jimmy K -
Sears Technician
February 24, 2009
Q:

The walking belt of my Sears Proform crosswalk 831297364 has shifted to the right.I tried 6b in the manual?

A:

Be sure you are turning the left adjustment bolt counterclockwise and the right bolt clockwise.

You should remove the screws in the back of the end cap and lift the front edge of the end cap to release it from the clips then remove the end cap. Spray the adjusting screws with some WD40 to free them up and try again. You should let the treadmill run for 4-5 minutes after each adjustment as it will move very slowly from right to left.

Read More
Jimmy K -
Sears Technician

Top Parts