Model #831297161 LIFESTYLER Treadmill

  • Frame Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Lifestyler model 831297161 831297161 Lifestyler Lifestyler expanse 600

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Sherman_G_Wallace -
Sears Technician
May 12, 2014
Q:

My Lifestyler expanse 600 model 831297161 treadmill stops moving when walked on. There are no loose belts. Is it the motor or a board?

A:

The problem could be in the motor or the motor controller. This type of failure is more likely the controller than the motor.

The problem could also be because the walking belt needs lubrication. To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill and dump you off on the floor. If you move and stop, the belt needs lubricating.

The part number for the belt lubrication kit is 219168. You can buy it at [www.searspartsdirect.com]. The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication.

Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply ½ the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller and lift the belt again and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

Read More
Jimmy K -
Sears Technician
March 26, 2010
A:

OK THANK YOU.

Read More
Anonymous -
August 15, 2013
A:

HOW MUCH WOULD COAST FOR SOMEONE TO FIX IT FOR ME

Read More
Anonymous -
August 15, 2013
See more answers
Q:

I am trying to replace the belt on my Treadmill - Lifestyler Expanse 600 model # 831.297161. I have gotten to the point where it says to remove the front roller

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina F. -
February 02, 2012
A:

If you take the bolt out on both sides the roller will move just a little bit to one side or the other. Then you can take the opposing side out. You may need to pry on frame just slightly enough to where you can pop one end of the roller out.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
February 03, 2012
See more answers

Top Parts