Model #831294060 PROFORM Treadmill

  • Console/handrails
    3 Results
  • Motor/motor Hood
    3 Results
Find part by diagram >

Question and Answers

Q:

On my Proform 585s treadmill, when I press the Start button the belt drive motor will start then immediately stop. 831294060 Proform Proform 585s

A:

I know that it can be very inconvenient for you not to have your treadmill working properly. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Yadira B -
February 26, 2013
A:

Thanks but I don't see the link.

Read More
Greg -
February 26, 2013
A:

Thanks for contacting ManageMyLife.com. I understand how frustrating it is having trouble with your treadmill shutting down. We are here to help. Yadira did provide you a good link on this problem. I suspect a problem with the motor control board. Generally when the voltage or current gets to high, a safety circuit will shut everything down. When it comes to electronics, the parts can look brand new and be bad. Also, a wire may be unplugged. Just unplug the treadmill and check every wire plugged into the control board and power supply. If there is no unplugged wires, you may be able to confirm a bad control board by a heat test. Just put your hand on the control board after the treadmill shuts down. If the control board is burning hot, it is bad. Otherwise, you need a wiring schematic with a reference voltage at certain spots. I was not able to locate a wiring schematic to the treadmill. However, there may be one attached to the motor control cover or laying in the belly pan. I hope this helps.

To order treadmill parts, please visit SearsPartsDirect.com with the model number.

Please feel free to let me know if you need further assistance. We are always here to help.

Thank you for using ManageMyLife.com.

Read More
John H -
Sears Technician
February 26, 2013
See more answers
Q:

Does my Pro-Form 585s need any belt wax or powder?

A:

The walking board (part the belt rides on) may be worn out and needing to be replaced. This particular model has a lubrication free belt; the owners’ manual states the use of any lubricant is not advised. It goes on to say that silicone or other types of lubricants can damage the belt. I have included a link to the owners’ manual for this model number, please click the following Owners’ manual

If you would like to replace the walking board, I have included a link that you may use for parts purchases, please click here; Sears Parts Direct

If you require further assistance please resubmit question with more details. I will be looking forward to helping you again in the near future.

Read More
Landell -
Sears Technician
January 27, 2010

Top Parts