Model #831247232 PROFORM Treadmill

  • Walking Belt
    3 Results
  • Motor/hood
    3 Results
  • Uprights/base
    3 Results
  • Console
    3 Results
Find part by diagram >

Question and Answers

Q:

My pro-form 415 crosswalk stops Intermittently.

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide a little more information such as the make and complete model number of your product so your expert will be able to provide you the best possible answer. Just click on reply below where you can provide the additional information.

Read More
Alina -
December 29, 2012
A:

It is a pro-form crosswalk 415, model 831.24723.2.

Read More
Albert Eitsert -
December 29, 2012
A:

Thank you for your question.

I am sorry you are having a problem with the treadmill. By what you have stated I suspect the walking belt is dry. When the belt is dry, it causes the motor to work harder and will stop if a heaver person tries to walk on it. To test the walking belt lubrication, do not turn the treadmill motor on. Set the elevation to the highest level. Stand near the front of the walking belt. Push yourself firmly toward the rear of the treadmill. If the belt is properly lubricated the belt will take you to the rear edge of the treadmill to the floor. If you move and stop, the belt needs lubricating. The part number for the belt lubrication kit is 219168. You can buy it at [ Sears parts direct | Sears Parts Direct . The cost is around $4.00. The application instructions should be in the package, but in case they are not here is how to apply the lubrication. Turn the walking belt until the belt seam is along the top of the front roller. Raise the belt on one side in the center of the walking board front to back as high as you can. Apply � the tube of lubrication to the walking board in a zig zag fashion moving from front to back. Move the belt until the seam comes up on top of the rear roller, lift the belt again, and put the rest of the lubrication on the walking board in the same manner. Turn the treadmill on and walk on the belt for 10-20 minutes. Walk all over the belt to distribute the lubrication evenly on the walking belt and board.

If the belt seems to be fine, the problem could be a motor control or a motor. Both of these parts can be expensive to replace. To be sure, I recommend having a service technician come out and diagnose the problem. you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Please let me know if you need further assistance on the treadmill.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 31, 2012
A:

Thank you very much. I will give it a try.

Read More
Albert Eitsert -
January 01, 2013
See more answers

Top Parts