Model #7975 SEARS Lamp Outdoor

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Refrigerator Error Code

A:

Good morning..... I can appreciate your concern over your length of time away effecting your refrigerator. You might have a frozen water line to your ice maker. I did locate a link that will discuss your situation in greater detail. Though this link discusses a different model number, the mechanics are likely going to be very similar. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will help guide you as to what might be wrong with your refrigerator and have a nice day.

Read More
Henry -
April 12, 2013
A:

Thank you for submitting your question. I understand your concern and I will be happy to assist you. Henry has provided you with good information from the link above. In most cases the ice maker fan and main control board for the refrigerator will need to be replaced. I also recommend scheduling for service to have a technician run some voltage checks to see which part needs to be replaced, if not both. You can schedule for service online with our Sears Home Services team. I hope this helps. Thank you for using Mange My Life.

Read More
Tykara -
Sears Technician
April 13, 2013
A:

Tykara, this sounds very expensive. This is the second repair on this appliance that is only about 2 years old. We have been loyal Kenmore customers since 1967, but this may be the last one. Our new Sears garage door opener also has issues.

Read More
Chad -
April 16, 2013
See more answers
Q:

I have an "icicle" hanging from my auto ice maker. If I chisel it,the ice maker will work. There's also a rather loud humming sound coming from the freezer.

A:

The problem with icicle and the freezer humming is concerning. I did some research on your model number but was not able to find what would causing the problem. Your expert will be able to help answer your question. It may take 24-48 hours. I do hope that everything works out.

Read More
Marc -
November 27, 2012
A:

Thanks for the inquiry about your refrigerator, I will be glad to assist you with this.
Based on your explanation I suggest that the ice maker may be over filling and causing the icicle, as well as the excessive fill causing frost or ice on or near evaporator fan (the noise).
Changing the filter could have caused the ice maker inlet to have surges from the air that gets into the water system when a filter is changed.
I recommend thawing the unit out long enough to melt any ice buildup behind the ice maker and evaporator coil. Suggest disconnect power, (store food in safe place) leave unit disconnected over night with doors open. Note: be prepared to deal with melting ice protect your floor! This will deice the coils and ice maker, connect power again and observe for any reoccurrence of problem.

Should you need additional assistance reply with more details and I will be happy to respond.

Thanks Ron H.

Read More
Ron H -
Sears Technician
November 28, 2012
See more answers
Q:

ice problems on Kenmore model 795.7975

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina F. -
January 12, 2012
A:

Thank you for your question. I understand your concern about this ice build up. This type of problem occurs when the drain freezes closed. The drain will need to be cleared to correct this problem. To access the drain, the back panel in the freezer will need to be removed. This means everything in the freezer will need to be removed and also the freezer drawer. I'm attaching pictures with instructions to remove and replace the drawer. The back panel will pull out, when you get access to it. Be sure to disconnect power to the unit first. When the panel is removed, you will see the drain under the evaporator. Hot water can be used to clear the drain. I hope this will help you. If you would like more assistance, reply to this thread and please include the complete model and serial number and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
January 14, 2012
See more answers