Model #79680318900 KENMORE Residential Dryer

  • Control Panel And Plate Parts
    3 Results
  • Cabinet And Door Assembly
    3 Results
  • Drum And Motor Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Loud noise and vibration in dryer 79680318900 Kenmore Dryer

Q:

need to remove panel to clean lint from inside dryer due to lint hose not properly instilled 79680318900 Kenmore Dryer

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.

Top Plate:

1. Remove 3 screws on the upper plate.
2. Push the top plate back ward.
3. Lift the top plate
WARNING !
When you disassemble the control panel,
be sure to take gloves and careful panel frame’s
edge. Failure to do so can cause serious injury.

Control panel:
1. Remove 2 screws on the control panel frame.
2. Disconnect the connectors.
3. Pull the control panel assembly upward and then forward.
4. Remove 9 screws on the PWB PCB)assembly, display.
5. Remove 4 screws on the PWB(PCB)assembly, main.
6. Disassemble the control panel assembly.

Cover Cabinet:
1. Disassemble the top plate.
2. Disassemble the control panel assembly.
3. Disassemble the door assembly.
4. Remove 2 screws.
5. Remove 4 screws from the top of cabinet cover.
6. Disconnect the harness of door switch.


WARNING !
When you disassemble the lamp connector, be
sure to take gloves and careful cabinet edge.
Failure to do so can cause serious injury

TUB DRUM [FRONT]:
1. Open the top plate.
2. Remove Cover Cabinet.
3. Disconnect the door lamp and electro 
sensor connector.
4. Remove 4 screws.
5. Disassemble the Tub Drum [Front].

BACK COVER:
1. Open the top plate.
2. Remove the Cover Cabinet and Tub Drum [Front].
3. Remove the Drum assembly.
4. Remove 7 screws.
5. Pull the Tub Drum [Rear] towards the front.

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
July 20, 2015
Q:

need mounting hole locations and thread size on the bottom of the washer 79640318900 and 79680318900

A:

Thanks for the inquiry and for being a valued member.

There wasn't much detail in regards to exactly what you were looking for the thread size and location of. I presume you were referring to the leveling legs for the base of the washer. 

Unfortunately, it doesn't appear the manufacturer of this washer has released the specifications for the thread size for the leveling legs. It may be considered proprietary. The mounting hole locations will be at each corner of the washer. Sometimes it helps to tilt the washer back when installing the legs to line them up with the mount holes. The leveling legs are still available, and the part number is AFC72755401.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
January 12, 2015

Top Parts