Model #79578316802 KENMORE Bottom-Mount Refrigerator

  • Case Parts
    3 Results
  • Freezer Parts
    3 Results
  • Refrigerator Parts
    3 Results
  • Door Parts
    3 Results
  • Ice Maker Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Replacement plastic part for bottom freezer 79578316802 Kenmore Refrigerator

Q:

deli drawer price? 79578316802 Kenmore Refrigerator

A:

Good morning.... The website Sears Parts Direct.com is a very effective site for finding parts for almost anything. I provided a link below that will open a page to your particular refrigerator. When you visit this site, within 10 seconds, a box will appear inviting you to chat with an associate. I hope this link helps you and have a nice day

Read More
Henry -
November 11, 2012
A:

I know how important it is to have the right parts for your refrigerator. The deli drawer for this model is part number 3391JJ2018B, and will cost about $91.32 plus shipping and tax. You can order this from the link that Henry provide above. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
November 12, 2012
See more answers
Q:

Bad PCB on Kenmore refrigerator

A:

I know how important it is to have the refrigerator working all the time. In regards to your question I have done some research while you are waiting for your expert answer, I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Priscilla V -
September 09, 2012
A:

Thank you for your question. I understand your concern about the fuse in the board. Sometimes, the fuse will blow due to a problem in the refrigerator. Other times, it's just a weak fuse or a spike in the supply voltage. However, the fuse in these boards are usually soldered in place and because of this, it's not designed to be replaced. I hope this will help you.

Read More
Scott D -
Sears Technician
September 11, 2012
A:

Thanks for your response. The easier problem is replacing the fuse; a matter of unsoldering the blown fuse and soldering a new one in its place. I the overwhelming obstacle is finding the fuse. Is a 3AP 15R, fast blow, 15A 125V. It appears to be a bulk item sold to manufacturers. So it looks like that I am at the end of the trail, unless I can find a substitute. Thanks again for your help, Robert

Read More
Robert1165 -
September 11, 2012
A:

Robert, thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
September 12, 2012
See more answers

Top Parts