Model #79565012401 KENMORE Bottom-Mount Refrigerator

  • Case Parts
    3 Results
  • Refrigerator Parts
    3 Results
  • Freezer Parts
    3 Results
  • Door Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

ice in bottom of freezer 79565012401

Q:

my Kenmore refrigerator Model 79565012401 will not stop beeping

A:

A constant beeping noise would urge anyone to want to repair their refrigerator. I found three links that may provide you with an answer to your question. I attached the links below, just copy and paste. I hope this helps! http://www.managemylife.com/mmh/questions/220273-kenmore-elite-refrigerator-beeping http://www.managemylife.com/mmh/questions/150981-why-does-my-refrigerator-keep-beeping-even-with-the-doors-closed http://www.managemylife.com/mmh/questions/198061-why-wont-my-refrigerator-stop-beeping

Read More
Jacqueline S -
October 29, 2010
A:

Jacqueline S. provided some links for previous answers in the first response that indicate the beeping could be caused by a control problem. The image below shows the causes of beeping in this particular model. You could have a problem with the door, door switch or the electronic control board on the back of the refrigerator if the beeping is apparently caused by the door alarm. If the beeping is constant and apparently caused by a stuck button on the display, then you may have a bad display control board or a bad main control board.

I recommend that you have a service technician diagnose and repair these types of problems on your refrigerator. Here is a link for the Sears Service website: Sears Home Services .

If you are advanced in technical skills and want to fix this problem yourself, reply with additional details about the beeping and we will try to assist you further.

Read More
Lyle W -
Sears Technician
October 31, 2010
See more answers
Q:

How do you install a gasket?

A:

I understand how important it is to properly install a door gasket. While you are waiting for an expert answer, I did manage to find a useful link about another person that wanted to replace a gasket on there fridge. I hope this link is helpful.

Read More
Joseph P. -
August 30, 2010
A:

This gasket should just press into a channel on the inner door panel of the freezer door. The part number that you provided is for the freezer door gasket. You may need to soak the new gasket in warm water to remove the creases in it. You can also smooth out the creases by using a heat gun or hair dryer on a low heat setting. Pull the old gasket off of the door and press the new one in place. You can lubricate the gasket with a small amount of Vaseline petroleum jelly to help the door close smoothly and preserve the new gasket.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
August 31, 2010
See more answers

Top Parts