Model #79098023800 KENMORE ELITE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Maintop
    3 Results
  • Doors
    3 Results
  • Wiring Diagram
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore elite range surface burner element doesn't turn off 790.98023800

Q:

Lower oven takes forever to heat up. 79098023800 Kenmore Elite Electric range

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your range. Upon researching model79098023800;  you can unplug the range power cord and remove the heating element and the oven temperature probe when the oven is not hot. With the parts removed you can test the parts for continuity using a multi meter, if any of the two parts test reads no continuity then that part may need to be replaced. If both of the parts test reads continuity then you may need to replace the electronic control board.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

I trust this information will help you, we appreciate your business thanks for choosing Sears.

Read More
CarlosZ -
Sears Technician
August 06, 2015
Q:

F20 code - not heating up 79098023800 Kenmore Elite Electric range

A:

Thank you for contacting Sears. I will be more than happy to assist you with your Kenmore range.

I can understand the frustration of your range not functioning properly, after researching model number 790..98023800. The "F20" fault code implies a communication failure between EOC (electronic oven control) and ESEC (electronic surface element control) system. In this case its difficult to test and tell what needs to be replaced. I would highly recommend contacting a technician.

I hope you found this information useful. Again thank you for choosing Sears. We appreciate your business, have a great day.

*Safety disclaimer before you try and repair the unit make sure the power supply is disconnected. There may be sharp parts to the unit that can cause injury to you if not careful. If you don’t not feel comfortable checking this yourself you can request a technician by visiting www.SearsHomeService.com*

Read More
Benny23 -
Sears Technician
August 06, 2015

Top Parts