Model #79096614407 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Kemnore electric oven Right rear element remains warm to touch and warm light remains on for several hours 790.96614407

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your stove. Upon researching model790.96614407; it sounds like the surface element switch may need to be replaced. It’s normal for the surface elements to be hot after use for some time, but if the element remains hot after you turn it off many hours later then the switch may have failed. The switch allows the element get the power necessary to get hot. It sounds the switch is still allowing the element to get hot after it remains turned off. I have posted a link of the switch to view the link click here.

I trust this information will help you, have a great day.

Read More
CarlosZ -
Sears Technician
February 22, 2015
Q:

Instructions for installing door seal- oven door

A:

Door gaskets are often the first part that needs to be replaced on many appliances. While you wait for step by step instructions from the expert for your model, you can check the schematics below for some guidance. Just click on the image needed, then scroll over to view the exploded image. Hope this helps!

Read More
Barbara H. -
February 18, 2011
A:

Thank you for your question and I understand your concern. I must assume the door seal is needing replacement because of physical damage and not because the door is shutting completely. If the door seal is not damage it will not likely need to be replaced. The oven door hinges will need to replace if the door is not shutting/closing completely in order to make a good seal.

The door seal has several clips that hold the gasket in position. You should be able to pry the clips out and remove the old door seal. Position the new seal so that all the clips will align to the proper holes and push the clips in. If the two ends have to tuck under, I added some addition information in the images below.

I added a youtube video that shows how the seal is removed and installed. It will show the seal mounting on the oven frame instead of the door but the procedure is the same.

Read More
Joey S -
Sears Technician
February 19, 2011
See more answers
Q:

How do I install the new control panel on my Kenmore electric range?

A:

Please see the images provided for the information you requested on accessing & replacing the control board for your Kenmore range.

Remember to disconnect power before attempting repairs.

Read More
biker dave -
Sears Technician
October 30, 2009

Top Parts