Model #7909642940A KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

removing Simmer Select Push Button

A:

Removing some parts and knobs can be difficult. The exploded diagrams at Sears Parts Direct may help see how this knob is attached. I attached the link for this model below. I hope this helps while you wait for the expert.

Read More
Barbara H. -
July 06, 2012
A:

Thank you for your question on the removal of the knobs on the front control panel on the range.

This switch has a sleeve that snaps into the hole on the control console. You will have to remove the rear panel to be able to remove the switch from the locking insert in the control console panel.

There are tabs on the sleeve that you will need to compress to remove the switch from the sleeve and then compress the tabs on the sleeve to remove it from the panel.

The sleeve goes into the panel from the front but the switch goes into the sleeve from the back and you will need to release the switch before you can release the sleeve.

I hope this will help.

Sam A.

Read More
Sam A -
Sears Technician
July 10, 2012
A:

where are the tabs on the inside

Read More
TIM -
November 09, 2013
See more answers
Q:

I have a eletric range kenmore #790.9642940A 7 its made a loud pop sound then stoped heating. I called magagemylife & they let me know it maybe a heating

A:

I'm sorry to hear that you are having some difficulties with your range. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
Joseph P. -
November 15, 2011
A:

Check your house circuit breakers or fuses if the stove top burners are not heating. You could have a voltage supply problem in that situation.

That loud pop was likely a relay on that clock control board in the console. I recommend that you unplug the range and access that clock control board as shown in this repair video: Range Clock Control Replacement . Look at the back of that control board once you remove the back panel of the console. You will likely see burn marks on that control board. If you do, then this verifies that the clock control board (part 316557207) will need to be replaced. You can order that part from the Sears PartsDirect website. Here is a direct link for that part: Clock Control Board . Be sure that you unplug the range before accessing internal components and replacing that clock control board.

If you see no visible damage to that clock control board, it may still be bad. You could also have a wiring failure between that clock control board and the oven element. Check the wiring on that control board (with the range still unplugged ). The bake element will be connected to that control board through a yellow and orange wire.

These tips may help you fix this range problem. If you need more help, reply with additional details.

If you get to a point where you want to have a technician repair the range, you can schedule one through this website: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 16, 2011
See more answers
Q:

i cant get self-cleaning to start on oven 7909642940a

A:

Generally speaking if your range will not program or start a cleaning cycle it will display an error code in the display. I added the instructions and error codes in the image below. Resubmit your question and additional details for further assistance.

Read More
Joey S -
Sears Technician
May 03, 2010

Top Parts