Model #79096414400 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Replacement of oven panel on Kenmore Electric Range Model # 790.96414400.

A:

I'm sorry that you are having some difficulties with your Kenmore Range. Managemylife.com is a great web site to receive expert assistance to just about everything. I did some research for you at managemylife.com and found an expert answer to a similar question that may shed some light on this problem. I have attached the link below. If any parts are required, I have attached a link to Searspartsdirect.com and your specific model Electric range. I hope the provided links assist you until your expert can respond to your specific question.

Read More
James -
May 21, 2011
A:

That is the correct part number for the bottom oven panel in your range. You should be able to remove that panel by removing the thumb screws on that back edge of that panel. Lift the back of the panel up slightly and pull it back to release the front lip and then remove it from the oven.

You can order that part from the Sears PartsDirect website.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
May 23, 2011
See more answers
Q:

Why are the cook top and oven still locked 3 hours after I canceled the oven cleaning cycle?

A:

The electronic oven control board will not unlock the oven door and cook top following a cleaning cycle until it detects that oven temperature is below a certain safe set point. If the temperature sensor in the oven is bad then the control may still think that the oven is too hot. A failed oven control board could also cause this problem.

You can try unplugging the range for 5 minutes and plugging it back in. This will sometimes reboot and reset the control board if it frozen up due to a power surge or glitch. If that does not free up the control board then you can unplug the range and check the resistance of the oven temperature sensor probe. To access this component, you will need to remove the lower back panel of the range. The probe will be on the right side. It will have violet wires going to it. Unplug the wire harness connection and check the resistance through the probe. You should measure near 1100 ohms if the oven is at room temperature. If the resistance of the sensor probe is high then it will need to be replaced. If the resistance of the probe is normal then you can plug the probe back in and access the back of the control board by removing the upper back panel (with the range still unplugged) and then measure the resistance through the circuit from the control board. If the resistance through the circuit is okay then the electronic oven control board will likely need to be replaced.

You can order parts from the Sears PartsDirect website if necessary.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
February 17, 2010

Top Parts