Model #79096412406 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

What does the F10 error code mean?

A:

model number 79096412406

Read More
David -
April 13, 2011
A:

A non working Oven is not something any of us want to see. I have researched on the Manage My Life website and was able to locate similar information to the issue that you are having. While you are waiting for an expert to reply with a detailed answer I recommend to reply back to this thread with a detailed model number to your appliance. Which this will allow an expert to give a detailed answer. I have attached a link below if you would like to view.

Read More
Priscilla V -
April 13, 2011
A:

Thank you for choosing Manage My Life. The F10 error code indicates a runaway temperature condition. In order to test this, you will need to do the following:

Remove the oven temperature sensor probe and disconnect the two wires. The temperature sensor probe is likely removable from inside the oven cavity. Remove the two screws and slowly begin pulling the sensor out until you come to a quick disconnect plug. Disconnect the sensor plug and then insert one meter lead into the terminal of the temperature sensor plug and place the other meter lead into the other terminal of temperature sensor plug. Place the dial on your multimeter to 200K as shown in the image below. The temperature sensor probe should measure 1091 ohms plus or minus 5.3 ohms at room temperature of 75 degrees plus or minus 2.5 degrees if it's Okay. If it does not measure approximately 1091 ohms, replace the temperature sensor probe. If the oven temperature sensor has approximately 1091 ohms then the oven control board will most likely need to be removed and replaced.

You can purchase the parts you need at www.SearsPartsDirect.com . I hope this information helps.

Read More
Rgabriella02 -
Sears Technician
April 14, 2011
See more answers
Q:

May I use a 15.5 qt pressure canner on my glass top range?

A:

The user’s manual does not cover any information about it. I would not recommend using the 15.5 qt pressure canner on the glass top. I'm concerned with total weight of it sitting on the glass and the prolong use of the burner. It's better to be safe than sorry. If the glass top was to break, would cost $212.68 just for the top, not including the service fee and labor. Have you considered a single burner hot plate to place the canner on?

Read More
Joey S -
Sears Technician

Top Parts