Model #79096342500 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

How to replace front panel on my Kenmore Range

A:

I can see how difficult this would be without directions. The expert will review and respond with step by step directions for this model. I did attach the link to Sears Parts Direct parts diagrams if needed. I also found a similar question but for a slightly different model. I attached the link below if youi would like to check to see if it might work.

Read More
Barbara H. -
March 04, 2012
A:

Thank you for your question and I understand your concern.

There are no written instructions available to provide step by step instructions. The control panel and most parts do not come with instructions. This is usually common knowledge for service technicians that are experienced and have the mechanical knowledge and training.

Generally speaking; the control panel is fastened to the right and left backguard supports with screws. You will need to pull off all the knobs and remove the panel on the back of the control panel to access the control board, infinite switch and the red indicator lights. Disconnect the range from the power source before removing the panel from behind the control panel.

You will need to remove the control board, infinite switches, indicator lights and then the screws securing the control panel to the left and right backguard supports to remove the control panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 06, 2012
See more answers

Top Parts