Model #79096312403 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers


Kenmore Electric Range #79096312403: Error Code F10 came up, after the got my dinner on fire. In MML, I see that this code represents


I'm sorry to hear that you are having some difficulties with your Kenmore Electric Range. I did some research for you at and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. The expert who will assist you, can walk you through a repair like this or let you know if this may be something a technician should perform. He can also verify parts that may be required for you to order. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to I hope these links provided will assist you.

Read More
James -
September 27, 2011

The F10 indicates that you could have a bad temperature sensor probe or a bad electronic control board in the range. I recommend that you unplug the range and check the resistance of the oven temperature sensor probe. If you see mounting screws on the inside of the oven cavity, you can access the sensor probe using the procedure shown in the first image below. If there are no mounting screws on the inside of the oven cavity, then you can access the sensor probe from the back of the range. Pull the range forward and remove the lower back panel. The sensor probe should have violet wires going to it. Unplug the sensor probe and measure the resistance through this component using a volt/ohm meter. You should measure about 1100 ohms of resistance through this sensor probe. If the resistance is over 2000 ohms, it will need to be replaced. You can order a new probe from the Sears PartsDirect website. The part number is 316217001. Here is a direct link for that part: Probe . If the sensor probe is okay, you will need to replace the electronic oven control board (part 316418310). Here is a link for that part: Clock timer

Unplug the range and remove the upper back panel to access and replace this control board. Make a note of the wire connections before removing wires (take a digital picture if necessary). Remove the wires and mount the new control in the console. You will need to transfer the overlay to the new control. Attach the wires properly to the new control board. Reassemble and test the range.

If you need more help, reply with additional details and we will assist you further. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Korinna S -
Sears Technician
September 29, 2011
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show