Model #79096212404 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

F30 error code on Kenmore range model #79096212404 79096212404

Q:

Electric range is giving problems.

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina F. -
December 30, 2011
A:

Your details seem to indicate that the clock control will not power up unless a cook top element is turned on. This points to a voltage supply problem. You are probably missing the 120 volt L1 leg of 240 volt power that normally powers up that clock control board. When you turn on a stove top element, the voltage from the 120 volt L2 leg of power feeds over to the L1 leg and this causes that clock control board to power up. Based on that information, I recommend that you check the house circuit breakers or house fuses for the range outlet. If you find no problems there, I recommend that you unplug the range and check the wiring on the terminal block at the back of the range. The image below shows the wiring connections on that terminal block.

If those wiring connections are okay, then you probably have a bad outlet, a bad power cord or an internal wiring failure. Reply with additional details if you need more help with this failure.

If you need to have a service technician help you resolve this problem, you can schedule one through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 03, 2012
See more answers
Q:

F10 code on Kenmore oven

A:

It is not easy to adjust without a stove. Below I attached a couple links that will explain your issue in detail. I hope this helps!

Read More
Jackie S -
July 15, 2011
A:

The F10 code indicates the electronic oven control (EOC) has detected an over temp condition in the oven. This can be caused by an oven temperature sensor or the EOC (electronic oven control).

We can't test the EOC but we can test the oven sensor. To do this turn the power to the range off and remove the panel that covers the controls on the rear.

Disconnect the plug on the EOC that has 2 violet wires in it and read the resistance between the violet wires. It should read between 1000-1200 ohms at room temperature. If the oven sensor checks within this range the EOC is bad.

If the resistance is out of range take the lower panel off the rear of the range and disconnect the violet wires from the plug that goes to the oven sensor. Read the resistance of the sensor. If it is still not within the range the sensor is bad. If it measures within the range the problem is in the wiring from the EOC to the sensor.

Read More
Fred M -
Sears Technician
July 16, 2011
See more answers

Top Parts