Model #79096112405 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Oven elements 79096112405 Kenmore Electric range

A:

Thank you for choosing sears I would be happy to help you with your range. Upon researching model 79096112405 the F10 error code indicates a runaway oven temperature. The only way to reset the range, is to disconnect it from the outlet or go to the main circuit breaker of the home and switch it off for 20-30 minutes, then restore the power. If disconnecting the power for a few minutes does not help, the EOC (electronic oven control) may need to be replaced.

Follow these steps to replace the EOC:

Unplug the range.

Remove the rear access panel from the console.

Write down the wiring locations, or a digital camera may come in handy for this.

Remove the wiring being careful not to pull on the wires - pull on the lugs.

Remove the mounting screws that hold the control board in place.

The new board may not come with the overlay (this is the plastic piece the covers the front of the board with all the printing on it. This can be reused. Carefully remove the overlay and place it on the new board.

Install new control board using care not to handle the board components as much as possible.

Reconnect all wiring.

Reinstall back panel.

I posted a link below of the control board.

I trust that this information will help you, thank you have a great day.

Read More
Jeff Wallace Jr -
Sears Technician
December 12, 2014
Q:

Kenmore Electric Range Oven Light 79096112405 Kenmore Electric range

A:

Thank you for choosing sears I would be happy to help you with your range. Upon researching model 79096112405; based on the description provided, it sounds like you may need to replace the oven door light switch. When the door light switch goes bad it starts turning the oven light on and off during use. I have posted a link below of the light switch.

I trust that this information will help you, thank you have a great day.

Read More
Jeff Wallace Jr -
Sears Technician
December 09, 2014
A:

Hello again, Maybe I didn't clarify myself. The oven light in question is the one on the control panel above the stove top and not the light itself inside the oven. However,if your answer is still the same then can you please post the link that you were referring to as I don't see it anywhere. Thanks again and Merry Christmas Barry

Read More
Barry -
December 09, 2014
See more answers
Q:

Why are the burners on my Kenmore range pulsing off & on?

A:

This is normal operation for this model of range. The temperature switch pulses voltage to the burners to maintain the set temperature. Be sure to use the correct size of pots & pans to prevent heat loss. Click on the images provided for details.

Read More
biker dave -
Sears Technician
August 26, 2008

Top Parts