Model #79096014403 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers


Why am I getting the F10 fault code on my Kenmore electric range after replacing the EOC board twice?


Here are some tips that may help you resolve this problem:

  • If you have been checking the resistance of the RTD directly at the sensor, I recommend checking it through the wires that plug into the control board (Pins 12 and 13 on the P5 connector). A wire harness problem could be causing the control to detect high resistance through the temperature probe circuit.
  • Even though the RTD is testing good, you may try replacing it instead of the control board (or at the same time as you replace the control board).
  • Make sure that the P5 connector is plugged in properly. Look for any damage in the connections that could cause high resistance in the circuit.
  • Check the voltage at the outlet for your range using the diagram in the image below. Low voltage can damage the control board. NOTE: You should only check this live outlet voltage if you are completely confident in your technical ability to safely measure it using a volt/ohm meter.
If you are experiencing power surges or brown outs through the electrical lines, this could affect the control board circuitry.

These tips may help you resolve this problem. If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
March 13, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show