Model #79096009600 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Not Cooling 59658695890

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your refrigerator. Upon researching 790.96009600; If it’s not cooling at all, it first needs to be determined if the compressor is running. If the compressor is running, the problem will probably be in the seal system or with the compressor. It could be a low charge, a restriction or the compressor may not be pumping properly. These are checks a technician will be required to make. If the compressor is not running, it could be a problem with the starting device, the compressor itself or if the condenser motor is not running. A meter will be required to check the compressor and start device. Unless you have a meter and are confident in your repair skills, I recommend having a technician make these checks.

 I trust this information will help you, we appreciate your business thank for choosing Sears.

 

Read More
CarlosZ -
Sears Technician
August 18, 2015
A:

my wine cooler fridge compressor is not running, thermostat is sending signal, what can I check with a meter? I have and Know how to use? Model # 183.14242, compressor not kicking on.thermostat sending signal...is my problem the compressor or the relays?

Read More
Dan -
August 18, 2015
See more answers
Q:

Kenmore 790.96009600 Oven not heating - Broiler and stove top do work Kenmore 790.96009600

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your range. Upon researching 790.96009600; you can unplug the range power cord and remove the heating element and the oven temperature probe when the oven is not hot. With the parts removed you can test the parts for continuity using a multi meter, if any of the two parts test reads no continuity then that part may need to be replaced. If both of the parts test reads continuity then you may need to replace the electronic control board.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
August 18, 2015
A:

Thanks. Just one further question. What is a multi meter and where do I get one?

Read More
Melinda -
August 18, 2015
See more answers
Q:

why does the Element On indicator light remain on, after the Hot surface light goes off 79096009600 Kenmore Electric range

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your range. Upon researching model 79096009600; this type of problem is normally caused by a failed contact in one of the infinite burner switches. It is not likely caused by any other problem. Other than not knowing whether a burner is actually still on or not, it should not pose a significant safety threat. The troubleshooting would involve accessing the burner switches in the console with the range unplugged and then pulling the "element on" indicator light wire off each switch (one at a time) until the defective switch is identified. The bad switch would then need to be replaced.

I trust this information will help you, we appreciate your business thank for choosing Sears.

 

Read More
CarlosZ -
Sears Technician
April 07, 2015

Top Parts