Model #79095882303 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers


Why did my oven quit working?


I must assume that the electronic oven control will program and show that it’s baking. There is no fuse on the range that would prevent the bake and broil elements from heating. See image below.

The likely failure is the electronic oven control if the surface burners work. In order for both (bake and broil) elements to fail at the same time would likely indicate a failure in the control board. The failure is the lack of voltage supply at the "L2 OUT" terminal which is common to both bake and broil elements. In order to be certain, a volt meter will be needed to test the voltages supplied by the control board. When set on Bake, there should be 220-240 volts when measured across L2 OUT and BK. When set to Broil, there should be 220-240 volts when measure across L2 OUT and BRL. There also must 220-240 volts supplied to the oven control board when measuring across L1 and L2 IN.

I do not recommend checking voltages unless you have experience and feel safe and confident in doing so otherwise I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
September 22, 2009

What do you do if in fact there is no voltage between the two points you mentioned and all the other facts you recited are true? Can you buy a new switch , the whole boar or a new oven? Thanks. J. Henry

Read More
Delia -
October 29, 2012
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show