Model #79095882302 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Electric Range #790.95882302: The other I heard a loud pop, now everthing to work, with the exception of the display, nothing lights up. Do I replace

A:

The control panel is must be working in order to operate the oven. So I understand your concern. Upon researching your question I found a couple links that may help you with your situation. I also attached the link to the Sears Parts Direct website to purchase the parts you need. I hope this helps!

Read More
Jackie S -
May 16, 2011
A:

I cannot tell from your details whether the stove top burners work. If the burners do not heat, I recommend that you check the house circuit breaker or house fuses of the range. You could have a voltage supply problem that would prevent the oven and stove top burners from heating.

If the stove top burners heat, then you will probably need to replace that electronic oven control board (also called a clock control). Before ordering that part, I recommend that you unplug the range and check the wiring connections on that back of that control board. Here is a link for a video that shows how to access that part:

Range Clock Control Replacement

Check the red and orange wires that connected to the L2 IN and L2 OUT spades. Check the control board for a burned spot or other damage. Based on the loud pop that you heard, it is likely that the control board is damaged. Visible verification of that damage will probably help you determine that the control board definitely needs to be replaced.

The part number for the control board is 316557511. You can order that component from the Sears PartsDirect website.

Follow the steps in the video provided above to replace that control board in the console. Be sure that you unplug the range before accessing internal components.

NOTE: Since the control board likely shorted out, I also recommend that you unplug the range and check the bake and broil elements for damage. A shorted element could have caused the damage to the control board. Here is a link for a video that shows how to check the elements: Bake Broil Heating Element Part Testing . You should not have to remove the elements to test them. Remove the lower back panel (with the range still unplugged ). Remove one wire from the element and check the resistance as shown in that video. You should measure between 8 ohms and 50 ohms of resistance. You can also check for resistance between each terminal of the element and the metal cabinet to see if the element is shorted to the cabinet ground. You should not detect any resistance (should measure infinite resistance) between the elements and the cabinet ground. These extra checks on the oven elements may prevent you from installing a new control board and having it short out again right away.

If you need more help, reply with additional details and we will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 18, 2011
See more answers
Q:

Kenmore Model 79095882302

A:

I'm sorry you are having difficulties finding the owner's manual or spec sheet. Managemylife.com has experts who will get an answer to your question within 48 hrs.

Read More
James -
January 21, 2011
A:

I emailed the installation guide for this model of Kenmore range directly to you. That installation guide should have all of the technical specifications that you need to properly install the ranges.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
January 23, 2011
See more answers

Top Parts