Model #79095751990 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a kenmore glasstop 790.95751990 I was running a clean cycle. It kept beeping f3 so I opened the door. Ever since the lock light wont turn off and it keep

A:

Thanks for contacting ManageMyLife.com. I understand how frustrating it is having trouble with your range displaying an error code. We are here to help. Based on the symptoms this range may have 2 problems. The first problem is the error code F3. The "F3" fault code implies the oven temperature sensor probe is open and faulty. The oven temperature sensor is located inside the oven cavity on the left side. The oven probe can  tested with a multimeter and using the chart on the image below. Turn off the power to the range before removing any parts. The part number for the oven probe is 316111200. If the oven probe tested good and the F 3 error code still exists, replace the electronic control. The second problem is the door lock. The latch may return to the unlock position by the following steps:
   1  Open the oven door and hold down the light push button.
   2  While holding down the light button, set the electronic control for self clean.
   3  After the self clean cycle starts, cancel it. Keep the light button held down. Also, do not let the oven heat up.
   4  The oven should shut down and the door lock should return to the unlock position. Now, release the light button.
If the door latch does not move to the unlock position, repeat the steps above. Otherwise, the door latch needs to be replaced. I hope this helps.
 
To order range parts, please visit SearsPartsDirect.com with the model number.

Please feel free to let me know if you need further assistance. We are always here to help.

Thank you for using ManageMyLife.com.

Read More
John H -
Sears Technician
November 02, 2013
Q:

model 79095751990 oven did not clean and door is locked in closed position how to open hard reset did not work

A:

I know how important it is to have a good working range especially during the holidays. While you are waiting for your expert answer, I did some research on the range. At this time, I was unable to locate information that would be helpful in regards to your question. Your expert will answer within 24 to 48 hours with detailed information. Thank you for using Manage My Life.

Read More
Joseph P. -
December 24, 2011
A:

You might try the expert link below.

Read More
Barbara H. -
December 24, 2011
A:

That link for a previous answer that Barbara H. posted in the above response may help you with this failure.

If that does not help, then you may need to access and replace that door lock assembly. The parts image below shows the door lock mechanism in this range. The motor is at the back of the range. You can unplug the range and remove the back panel to access that door lock motor assembly. You can probably unlock the oven door by releasing that latch rod and manually retracting that hook.

Once you get the oven door unlocked, you may be able to use the oven. You will probably need to replace that door lock motor assembly to permanently fix the range. You can order parts from the Sears PartsDirect website if necessary. Be sure that you unplug the range before accessing internal components.

A wiring failure or a problem with the clock control board in the console could also prevent the oven door from unlocking.

If you need more help, reply with additional details and we will assist you further.

If you get to a point where you need to have a service technician repair this failure, you can schedule one through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 27, 2011
See more answers

Top Parts