Model #79095594102 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
  • Wiring Schematic
    3 Results
Find part by diagram >

Question and Answers

Q:

F1 message on oven. Top element won't turn off

A:

I found a question on Manage My Life under the Answer button that is similar to the one you asked. I think this information will be very helpful to you. I attached the link below. I hope this helps!!!!

Read More
Raquel F -
July 13, 2010
A:

In this situation, the F1 is indicating a runaway (extremely high) temperature since the broil element relay was apparently stuck closed to cause that element to heat constantly even when the oven was off. It is not likely that you will be able to re-program the electronic oven control board. When it is frozen up or stuck due to a power surge or glitch through the electrical lines, you can sometimes "re-boot" the electronic oven control board by unplugging the range for 1 minute and then plugging it back in. I assume that you may already have the range unplugged. You can try plugging it back in briefly to see if the broil element still heats constantly even though the control is not programmed for the broil or bake cycle. If it does then the electronic oven control board (part 316207502) will need to be replaced. You may also need the overlay (part 316220819) unless you can peel the original one off the control and reuse it. You can order parts from the Sears PartsDirect website.

If you replace this control yourself, be sure that you unplug the range before accessing this component. Remove the upper back panel to access the control board. Note the location of the wire harness connections (I recommend that you take a digital picture). Remove the wires and replace the control board. Reassemble and test the range. NOTE: Internal metal edges (and the edge of the upper back panel) can be sharp. Protective gloves are recommended when completing this repair.

If you need more help, submit additional details and we will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
July 16, 2010
See more answers
Q:

What would cause my Kenmore electric range to not heat?

A:

Based on your details the symptom indicates a voltage supply failure or a floating Neutral. I recommend locating both circuit breakers dedicated for the range and flip both breakers OFF and ON 2-3 times and recheck operation.

It’s not likely a lack of voltage but the loss of the Neutral line. It could have loose neutral line in the range or in your electrical supply. This type of failure will likely require an electrician and possibly an appliance technician.

The voltage supply and neutral will need to be tested while under a load with a volt meter. The volt meter should measure 110-120 volts between red and white and between black and white and it should measure 220-240 volts when measuring between red and black.

I do not recommend checking voltages unless you have experience and feel safe and confident in doing so, otherwise I recommend calling a service technician.

Read More
Joey S -
Sears Technician
September 03, 2009

Top Parts