Model #79095314300 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
  • Wiring Schematic
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Electric Range

A:

Having a properly working range is very important. The problem with the range not heating as it should can be frustrating. I found some information for you that I am hoping will be able to help you. Please click here:[Kenmore Electric Range]. Your expert will also help answer your question. It may take two business days for your expert to reply. I do hope that everything works out on the range.

Read More
Marc -
July 09, 2013
A:

Thank you for your question and I understand your concern.

If you can confirm the bake element and the broil element will heat, the intermittent oven operation is most likely caused by the electronic oven control/clock assembly. When the oven is cold, turn on the broiler and confirm it will get hot and then turn off the broiler and turn on the bake cycle and confirm the bake element gets hot. If both will get hot, I suspect an intermittent relay operation on the electronic oven control/clock assembly.

You should also disconnect the power cord and then remove the cover from behind the control panel and remove the panel behind the oven cavity. Look at all the wiring connections on the bake and broil element and the wiring connections on the back of the electronic oven control/clock assembly. Look for any signs of a blackened or darken wire connection. If all the connections look normal, replacing the electronic oven control will most likely resolve the intermittent oven operation.

The electronic oven control is part #316455400 which can be ordered from Searspartsdirect.com.  There is also an overlay stuck on the face of the electronic oven control/clock that will need to be peeled off and re-attached to the new oven control. If the old overlay does not stick well to the new control, you will need to order a new overlay part #316220702.

NOTE: Before removing the rear panels, disconnect the power cord from the power source. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
July 10, 2013
A:

What is it that the Probe,oven temp part does?

Read More
Cindy -
July 12, 2013
A:

Cindy: The oven temperature probe located inside the oven cavity senses the oven temperature. The oven temperature sensor changes Ohm resistance as the oven cavity temperature rises and falls. The electronic oven control/clock assembly is constantly monitoring the Ohm resistance of the oven temperature sensor. When the oven temperature drops, the oven control closes a relay to cycle on the bake element. The broil element also alternates operation with the bake element during the bake cycle. At room temperature, the oven temperature sensor should measure approximately 1100 Ohms when disconnected and measured for resistance with and Ohm meter. I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 15, 2013
See more answers

Top Parts