Model #79095312300 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
  • Wiring Schematic
    3 Results
Find part by diagram >

Question and Answers

Q:

how to disconnect oven

A:

I understand that you want to disconnect the oven properly. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question. Have a great day!

Read More
Alina -
October 20, 2012
A:

Thanks but I know to disconnect from power. What I was wanting to find out is how do I PERMANENTLY disconnect the oven since I will soon be replacing but in the meantime I could still use the stovetop.....

Read More
janice -
October 20, 2012
A:

I know that it can be very difficult to have issues with your range. In order to disconnect the oven from the rest of the range, you will need to "unplug" the Bake and Broil connections on the control board. This will stop the power from going into the oven, but the cooktop will still work. I do not recommend that you run the range without everything connected. You should replace it as soon as possible. If you are going to try this, please disconnect the range from the power first. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
October 21, 2012
See more answers
Q:

Why is the my Kenmore oven model 790.95312300 not getting hot?

A:

You could have a failed element, a bad electronic control board or a wiring failure that is causing this oven heating problem. A failed temperature sensor probe can sometimes cause a heating problem. Try setting the oven on the broil function to see if the broiler heats properly. If it does, then the temperature sensor is likely okay. You could have a failed oven bake element. If you are able to unplug the range and carefully access the heating element, you can check the resistance through this component. Unplug one wire from the element (with the range still unplugged) and measure the resistance across the leads of the element with a volt/ohm meter. If you measure infinite resistance (open), then the element has failed and will need to be replaced. If the element is okay, then you could have a wiring problem between the element and the electronic oven control board or you could have a bad control board.

A technician is normally needed to check the control board. Live voltage checks are usually required to determine whether a control board needs to be replaced. I do not recommend that you attempt to conduct live voltage checks yourself. This is why I recommend calling a service technician if the element and the wiring appear to be okay. You should also call a technician if you are not completely confident in your technical ability to safely disconnect electrical power and access internal range components.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
March 09, 2009
Q:

How do I remove a black film on my glass cooking surface?

A:

Refer to the image I sent for cleaning procedures or refer to your user's manual for cleaning the glass top.

Read More
Joey S -
Sears Technician
June 09, 2008

Top Parts