Model #79095262991 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Clean cycle

A:

When the lock mechanism is enabled and your door is open it can be difficult to undo this issue without the proper instructions. I was able to find some links that may help you get the door unlocked on your range. I attached the links below. I hope this helps.

Read More
Jackie S -
March 30, 2012
A:

Those links for previous answers that Jackie S. posted in the above response may help you resolve this problem. Pressing and holding the oven door light plunger switch in while clearing that self clean cycle will likely cause that oven door lock bar to retract. Here is a link for the owner's manual on your range in case you need it: Owner's Manual .

You can use that manual to help you clear that self clean cycle if necessary.

These tips may help you resolve that oven door lock problem. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
April 02, 2012
See more answers
Q:

Serious oven problem

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina F. -
October 28, 2011
A:

I understand your concern about this dangerous condition. Your details indicate that you have a bad clock control board in the console of that range. That clock control board has relays that control the oven elements. I recommend that you unplug the range until that clock control board is replaced. Since the oven was overheating, I recommend that you have a service technician examine the range to see if other components were damaged. Here is a link for the Sears Service website: Sears Home Services .

You may consider replacing that range. Most of the new models have safeguards that will protect against the failure that you are describing.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
October 28, 2011
A:

I appreciate your response. I purchased this range new about five years ago. It seems like it should last longer than that to have to be replaced. Unfortunately, when you start getting technicians involved with diagnosing problems and then paying for all the parts, it may end up being cheaper to just replace it.

Read More
Lisa -
October 28, 2011
See more answers
Q:

DL code on my range, what does that mean? how to erase code?

A:

Error codes can rise some concern. Below I attached a link from a previous post that may help you out. I also attached the link to the Sears Home Services website if you weould like to schedule service with a tech. An expert will respond shortly. I hope this helps!

Read More
Jackie S -
April 17, 2011
A:

Thank you for your question.

I can understand wanting to know where the DL code came from on the display.

I do not find that code in our technical information.

My first inclination is that it is a door lock situation.

Is it possible that you where putting it into clean and opened the door before the lock hooked the door?

Please reply with the a little more information and what the range is doing or not doing and I will be happy to help you.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 18, 2011
See more answers

Top Parts