Model #79095200103 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

My bottom oven heating element won't shut off

A:

Having a Rang that will not work properly can be frustrating.I have taken the time to research on the Manage My Life website and have found some information that you may find useful. While you are waiting for an expert to reply I have attached a link below.

Read More
Priscilla V -
March 16, 2011
A:

Thank you for your question and I understand your concern.

The "F1" fault code generally implies a faulty Electronic Oven Control (EOC) but it could also be caused by a faulty oven temperature sensor (RTD) or a burnt out and shorted bake element.

I recommend _disconnecting the power supply and remove and disconnect the bake element and checking the resistance of the bake element using an ohm meter.

I added a YouTube video showing how to test the bake element. The bake element should measure between 16 and 23 ohms. You need to also check across each element terminal to the heater casing too see if it's shorted to the case.

If the bake element is shorted, replace the bake element. Next, remove and disconnect the oven temperature sensor (RTD) and measure the resistance of it at room temperature. It should measure approximately 1100 ohms if it's Okay.

If the bake element and the oven temperature sensor tests Okay, replace the Electronic Oven Control (EOC). The EOC can be removed and replaced from the rear of the range by removing the panel from behind the console assembly. Note: Be sure to disconnect the power supply before servicing your range.

You can look up and order parts at Sears PartsDirect

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 17, 2011
See more answers
Q:

Why is the display not working on my Kenmore range?

A:

On something like this I would suspect that the electronic control has failed. The only way to confirm this would be to take a voltage reading at the supply for the control, L1 to neutral. Please see the image provided for wiring diagram information.

Read More
biker dave -
Sears Technician
Q:

Why does the F10 alarm keep going off on my Kenmore range?

A:

According to the model number you have submitted, this range does not list an F10 error code alarm. The alarm codes listed are F1, F3 & F9. The F1 is for a shorted keypad. F3 is for a shorted temperature sensor. The F1 with an F3 is an oven over temperature issue. The F9 is a failure of the door locking assembly.

If none of the error codes listed help you with this issue, please check your model number & error alarm code number & resubmit your question.

Read More
biker dave -
Sears Technician
June 12, 2008

Top Parts