Model #79094359700 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Range 79094359700 79094359700 Kenmore Electric range

Q:

seal installation 79094359700 Kenmore Electric range

A:

Thank you for your inquiry on your Kenmore Range, Model: 790.94359700. From reviewing the details on your model, I wasn’t able to find any instructions on your specific model but I was able to find a video on a similar model of range that shows how to install the door seal. The link will be found bellow.

Click Here  

Safety Warning: Before beginning the repair, disconnect the direct power supply to the range to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry93 -
Sears Technician
March 31, 2015
Q:

kenmore stove m 79094359700

A:

I know how concerning it is to find your range is displaying an error code. i was able to find a link that includes helpful information for the f30 error code. I attached the link below. I hope this is useful.

Read More
Jackie S -
July 08, 2012
A:

Thank you for your question and I understand your concern.

The "F30" fault indicates an open oven temperature sensor probe or an open oven temperature sensor circuit between the sensor connection and the electronic oven control. The oven sensor can be removed and disconnected from inside the oven control and tested for proper resistance with an Ohm meter. The sensor is located inside the oven cavity in the back upper left or right hand corner. If you can see two screws on each side of the sensor, it can be removed from inside the oven cavity. If you do not see any screws, the back panel on the rear of the range will have to be removed in order to access and disconnect the sensor for testing or replacement. If the sensor does not measure any resistance, replace the oven sensor.

The resistance of the oven temperature sensor should measure approximately 1100 Ohms at room temperature. NOTE: Disconnect the range from the power supply first if you have to remove the rear panel. Also, the information in the link Jackie provided in the first response mentions a possible open thermal safety switch; your model range does not have a thermal safety switch/fuse in the oven temperature circuit.

The oven sensor#316490000 for Kenmore model 790.94359700 can be ordered from Sears Parts Direct.

I added a video showing how to test the oven temperature sensor.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 11, 2012
See more answers

Top Parts