Model #7909422940A KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Range Oven Problem

A:

I'm sorry that you are having some difficulties with your Kenmore Range. I did a little research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. Your expert can walk you through a repair like this and even help you order any required parts. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com

Read More
James -
July 23, 2011
A:

The link James R sent explains the cause of the F10 error code. When testing the oven temperature sensor, an ohm reading between 1000-1200 is a good sensor.

I suspect the broil relay on the control is welded closed and leaving the broil element on. This would mean the clock/timer needs to be replaced.

The overlay is stuck on the front of the control and can usually be removed and installed on the new control. Heating the overlay with a hair dryer will make it easier the remove and install.

You can order the parts and see a parts diagram for the range at Parts Direct

The part number of the oven temperature sensor is 316490000, and the price is $14.57.

The part number of the clock/timer is 316557108, and the price is $125.49.

The part number of the overlay is 316419109, and the price is $19.76.

Read More
Jimmy K -
Sears Technician
July 25, 2011
See more answers
Q:

What would cause my surface element to get extremely hot when set on low?

A:

The burner switches controls the operation of the surface elements. If you are not able to control the surface element by turning the burner switch to low, the switch has failed. In order to remove and replace the bad burner switch will require disconnecting the power supply from the range. Removing the burner knob and the two screws which were hidden by the knob. Remove the cover from the back of the control panel. Make a note of where the wires are attached to the old switch before disconnecting so that you will know where to attach them on the new burner switch. NOTE: Disconnect the power supply from the range before servicing.

I added a link below to Sears Parts Direct with the image and parts diagram of your range. Click on "Browse subcomponents" to open link. Click on "backguard" for the console image.

Read More
Joey S -
Sears Technician
November 06, 2009

Top Parts