Model #79091062603 KENMORE Free Standing, Electric

  • Backguard
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Electric stove will not heat

A:

Diagnosing heating problems in a electric stove can be hit or miss. I see you have already replaced some parts. I did locate two similar questions for this stove that may help while you wait for the expert response. I hope this information helps find a resolution to this issue.

Read More
Barbara H. -
May 05, 2012
A:

Thank you for your question and I understand your concern.

The only proper way of diagnosing if the control board is faulty is to check the voltage to the bake element after programing a bake cycle. You can access the bake and broil element leads at the bake of the range after removing the rear panel. You should measure 220-230 volts when measuring across the two leads. Leave the wires connected to the elements when checking the voltage. NOTE: I do not recommend measuring the voltage unless you have experience and feel safe and confident in doing so; otherwise I recommend calling a service technician to diagnose and repair your oven.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
May 07, 2012
See more answers
Q:

oven

A:

The oven not heating can be an inconvenience and keep you from cooking up some baked goods. I am adding a link below that will provide you with some troubleshooting tips. I hope this helps while you wait for your expert response .

Read More
Joseph -
March 12, 2012
A:

Thank you for your question and I understand your concern.

If the surface elements will heat up and neither bake or broil elements will heat up, the most likely failure is the EOC (electronic oven control).

The EOC is part #316455420 which can be ordered from Sears PartsDirect .

In order to access and replace the electronic oven control, remove the panel from behind the console. The control board is fastened to the bracket with screws. Note: Disconnect the power cord from the power source before removing the panel from behind the console.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 13, 2012
See more answers
Q:

Oven Not Heating Up

A:

I hope you had an oven mitt on when you grabbed that rack. I would be upset if dinner was still half raw after thinking it was cooking. While you wait for the expert to review your model, you can check two other expert posts with similar questions if you like. One may have an answer that helps. I attached the links below.

Read More
Barbara H. -
February 03, 2011
A:

Thank you so much for the assistance Barbara. I have look at it and I still don't understand why it is not working properly.

Read More
Lucretia -
February 04, 2011
A:

I know it's frustrating when the oven stops working. You have already received some very good information to check the bake element. If the bake element is ok and the wires are not broke, it will indicate, a possible defective electronic control. I would recommend having a technician check this first before replacing the control. I�m listing a site you can access, to have a tech come out. Here is a link for the website: Sears Home Services . If you would like more assistance, any additional details will be helpful and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
February 05, 2011
See more answers

Top Parts