Model #79079623700 KENMORE PRO Range, Electric/Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Maintop
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Age of range

A:

Thank you for choosing sears I would be happy to help you with yourrange. Upon researching model 79079623700; based on the information provided this model is showing to be from 2007.

I trust this information will help you, have a great day.

Read More
CarlosZ -
Sears Technician
February 19, 2015
Q:

Range keeps beeping, trying to maintain temperature 79079623700 Kenmore Pro Range

A:

Thank You for choosing Sears PartsDirect.com. I regret to hear that you are having issues with your Kenmore Pro  
and do understand your frustration. Glad to help out. Im looking at your model number 79079623700 and there is a calibration that must be done when replacing the sensor probe. It is page 21 in the owners manual. You must press and hold the CONV CONVERT button until "00" appears in the oven control display. I also recommend that you try to reset the electronic control boards in the oven by shutting off the house circuit breakers for the unit to completely disconnect electrical power. Leave the power off for 5 minutes. Restore power and see if the control works properly. In some situations, that will resolve the problems that you are describing. 

The ERR code is normally displayed when the function knob is changed without turning the dial to Off first as shown in the first image below. If you are seeing that ERR code randomly when the oven is heating without changing the mode, then the mode selector potentiometer switch (part 318601700 or 318601500  may need to be replaced. You may also have a problem with the electronic oven control board (part 316460200). There is a chance that a wire harness connection failure could be causing this problem. You can check the wiring connections using the wiring diagram in the second image below as a guide.

The resistance of that oven temperature sensor probe appears to be lower than normal. Make sure you shut off the house circuit breakers for the oven and check the resistance from the electronic control board in the console.You can check the resistance through the entire sensor circuit using that information. These initial tips may help you resolve those oven problems on your own. 

Be sure that you shut off the house circuit breakers for the oven to completely disconnect electrical power before accessing internal components and replacing parts. 

You should be able to access the control board in the console by opening the oven door and removing the screws underneath the console. Lift the console and carefully fold it forward.

If you need more help, reply with additional details and we will assist you further.

Note: If you replace the electronic control board noted above, you will need to calibrate the potentiometer.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link

Read More
Sherman_G_Wallace -
Sears Technician
February 19, 2014
Q:

the LP conversion kit for the kenmore pro dual fuel range come with 8 orifices. the stove top burners have 9 orifices. 1 in each regular burner, 3 in the side 79079623700 Kenmore Pro Range


Top Parts