Model #79079383406 KENMORE ELITE Range, Electric/Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Broken oven element connector for Kenmore Elite Dual Fuel model 79079383406 79079383406

Q:

Broken connector 79079383406 Kenmore Elite Dual fuel range

Q:

Broiler does not work

A:

It can be very frustrating when your broiler will not work properly. I would suggest that you provide a little more information such as the make and complete model number of your product, so your expert will be able to provide you with the best possible answer. Just click on reply down below, where you can provide the additional information.

Read More
Julio -
October 29, 2012
A:

Sorry I have a Kenmore Elite Model # 790.79383406

Read More
Scott -
October 29, 2012
A:

There is not a fuse in that circuit but you could have a problem with the electronic oven control board or with the wiring that would prevent that broil element from heating. I recommend that you check the element for physical damage. If you see a break in the element, then it will certainly need to be replaced. If you do not see any apparent damage to the element, then I recommend that you check it with a volt/ohm meter before ordering that part. If you don't have a volt/ohm meter, you can buy one at your local Sears store or hardware store for less than $25. Unplug the range and access the leads of that element on the back of the range. You will need to remove the back outside panel to access the leads of the element. The broil element should have blue and orange wires attached to it. Pull off one of the wires and measure the resistance through the element using the volt/ohm meter. You should measure between 10 and 40 ohms of resistance. If you measure OL -- open load or infinite resistance then the element is bad and will need to be replaced. If that element is okay, then I recommend that you check the wiring between the element and the electronic oven control board in the console (with the range still unplugged ). If that wiring is okay, then you will probably need to replace the electronic control board in the console.

You can order parts from this page: Kenmore Range Model 790.79383406 Parts . Be sure that you unplug the range before accessing and replacing internal components.

If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
October 31, 2012
See more answers

Top Parts