Model #79079213300 KENMORE ELITE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

What if the oven is not getting hot?

A:


I assume you mean it doesn't heat in bake. Will it heat in broil? Does the ignitor glow bright red? If it won't heat on bake or broil you probably have a problem with a wire connection in the range. If it works on broil, look at the ignitor at the bottom of the oven and see if it glows bright red. If it doesn't you probably need a new ignitor. If it does glow red you should schedule service and let a technician diagnose and repair the oven.

Read More
expert -
Sears Technician
January 18, 2008
A:

Does not work or broil or bake. The igniter does get red hot, but it does not light up

Read More
Art -
March 22, 2011
A:

Is there an amperage check I can make? How do I determine that it is not a problem with the gas valve? part number off gas valve that feeds the burner - 9650 30874V NAT, below that NC-4125-5 below that 183D5746G001

Read More
Art -
March 22, 2011
A:

Does not work or oven bake . The igniter does get red hot, but it does not light up gas ranger kenmare model 790*7744 thank you email hernan@branchny.com

Read More
hernan101 -
October 11, 2011
See more answers
Q:

one of my stove burner is not fully flamed. half side is good, other half is not good

A:

I understand how important it is to have all of the burners working on your stove. While you are waiting for an expert answer, I did manage to find a link that will provide you with more information about your problem. I hope my link is useful.

Read More
Joseph P. -
September 09, 2010
A:

You need to clean the burner that is not burning correctly. To properly clean the burner you need to remove the burner cap and remove the 2 screws that hold the burner down.

Remove the burner and soak it in detergent and water for 12 hours. Scrape any remaining blockage from the burner openings.

Read More
Jimmy K -
Sears Technician
September 10, 2010
See more answers

Top Parts