Model #79079019102 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

my oven will not heat up in bake 79079019102 Kenmore Gas range

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can be when your range is not working properly. 

You will need to test the safety valve and the sensor probe. 

GAS SAFETY VALVE: 1.5 Ω
BAKE IGNITOR:  108 / 232 voltage   100 Ω

OVEN TEMPERATURE SENSOR PROBE: 1100 Ω * refer to chart attached. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the unit before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.


 

Read More
Natasha12 -
Sears Technician
August 09, 2015
Q:

Kenmore gas stove burners too low

A:

When cooking, it is important to be able to adjust the flame from high to low. I was able to find a link that includes great information for a similar issue. I attached the link below. An expert will respond shortly. I hope this helps.

Read More
Jackie S -
August 17, 2012
A:

Your details do seem to indicate that the range was converted to LP gas. I recommend that you check the back of the range for a packet that may still have the original natural gas orifices in it. If you cannot find the natural gas orifices for the stove top burners, then you may need to order new ones. The first image below shows the part numbers for the natural gas orifices on this range. You can order those parts from this page: Sears PartsDirect.com .

This conversion should be completed by a qualified installer.

I provided instructions for the conversion of that range in the pages below. The last page shows the procedure for converting the range back to natural gas. You can provide that information to the installer for conversion.

This information should help you resolve the burner problem that you are describing. If you need more assistance, reply with additional details.

You can contact your local gas supplier for a qualified installer. That installer may be able to drill you new natural gas orifices. This may save you the expense of ordering those new natural gas orifices as described above.

You may also be able to find a pre-screened service provider on the ServiceLive.com website that can complete this conversion.

Read More
Lyle W -
Sears Technician
August 20, 2012
A:

Here are additional pages of the conversion instructions.

Read More
Lyle W -
Sears Technician
August 20, 2012
See more answers

Top Parts