Model #79078634601 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

F11 code on Gas Range 790.7863

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com

I am sorry and do understand your frustration when having codes like the f11 on your range.

Glad to help out.   Im  looking at your Kenmore model number 790.7863.

Im sorry to say that you didn't give me a complete model number but it is enough for me to help you in what F11 means.

Your model number is found by pulling out the bottom drawer below the oven.   Look on the frame where you would push the drawer against in the upper area or under the front burners.

F 11 states it is a "SHORTED KEYPAD".

Suggested Corrective Action according to the technical manual is -

1.  Disconnect power, wait 30 seconds and then reconnect the power.

2.  If the fault comes back on the circuit board then you need to replace the electronic circuit board.

Without your full model number, I can't tell you exactly which one you will need.   If you write back then will be glad to show you the exact board.

 If you have further questions please let me know.

Thanks for choosing Sears PartsDirect.com


Read More
Larry L -
Sears Technician
October 04, 2013
A:

Thank you. The complete model # is 790.78634601. Is there any possibility that extreme amounts of steam could have caused a short or fault in the board? My wife was canning at the time, and two extra large pans will boiling liquids were producing profound amounts of steam. In addition to the F11 code, the clock twice switched to timer on its own and then back again.

Read More
Richard -
October 04, 2013
A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com

Richard thanks for writting back and sorry for the problems still having.   What I would do is open up the control panel and look at the wiring.   See if it feels damp with the steam that might of gotten through.   Wipe off the wiring and conncetors.   Put it back in and see if you still have the same trouble.

Good luck

 If you have further questions please let me know.

Thanks for choosing Sears PartsDirect.com

Read More
Larry L -
Sears Technician
October 08, 2013
See more answers

Top Parts