Model #79078614400 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Sealed burner cover not removes from range igniter/orifice 79078614400 Kenmore Gas range

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your range. Upon researching model 79078614400; the sealed burner just lifts straight off. Grease or debris could make the burner stuck. Try wrapping a towel around the burner and turning it and lifting up at the same time.

Thank you for choosing Sears. We appreciate your business. Have a great day.    

Read More
Jeff Wallace Jr -
Sears Technician
December 29, 2014
Q:

Switch replacement

A:

Thank You for choosing Sears PartsDirect.com. Glad to help out. Im looking at your model number 790.78614400 and the repair is fairly easy. First make sure the unit is unplugged or the breaker is swtiched to off. You will need to remove the grates, burner caps and burners, Under the burners there are 2 screws that will need to be removed. The top will now open up and back like the hood on a car. You will need to prop the door open. The light switch is located to the left side of the cabinet will pop out of place by depressing the small tabs.. The harness will need to be disconnected. If you have further questions please resubmit your question with a additional details. Thanks for choosing Sears PartsDirect.com. 
 
 
 
.

Read More
Sherman_G_Wallace -
Sears Technician
February 27, 2014
A:

Thank you very much, I will give that a try, it sounds easy, we'll see if I can find those two screws first then we should be good, I guess. Thanks again.

Read More
Richard -
February 27, 2014
A:

Well...I found the two screws under the burners. So there are 8 screws to remove. Anyway, I tried removing the first one, and no problem, went for the second and it just broke right off. So I put the first one back and not too tight, because I didn't want it to strip the hole. So I put everything back and guess I wont be able to access the switch. This range is about 9 years old, I think I got it in Feb of 2005. So the screws are just too corroded.

Read More
Richard -
February 27, 2014
See more answers
Q:

oven problem

A:

I know how important it is to have a good working oven in the home so that you can make some baked goods. I am sorry for the inconvenience and I did manage to find a link with a similar question. I hope this helps with your research while you wait for your expert response. 

Read More
Joseph P. -
March 14, 2013
A:

Thanks for the information about your oven model 79078614400; sorry you are having a problem. Based on the description you provided you will need to check out the circuit for the igniter. The igniter should receive 120 volts ac. Trace the wiring and start at the Control. I have attached a wiring diagram that will help you.  If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services. Ron H.

Read More
Ron H -
Sears Technician
March 15, 2013
See more answers

Top Parts