Model #79077483804 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

low flame on center burner 79077483804 Kenmore Gas range

Q:

Model # 79077483804, have ordered part 20A overlay to replace melted one. Is this easily replaced?

A:

I understand that you have ordered a part and need to replace it. An expert should be able to provide you with an answer within 24 to 48 hours. Have a good day.

Read More
Alina F. -
December 04, 2010
A:

Thank you for your question and I understand you concern. In order to access and replace the overlay the Electronic Oven control/Clock will have to be removed from the control panel. First, disconnect the power cord from the power source. Remove the metal shield from behind the control panel. Remove the screws securing the Oven Control/Clock to the control panel. Peel the overlay from the Oven Control/Clock and reverse the procedure to install the overlay and clock.

I added the general instructions in the image below.

Read More
Joey S -
Sears Technician
December 06, 2010
A:

Same Thing happen to me, and I see the pics but they are not clear, can u email pics to me : a diagram of coloref wires that are on the back of the control Baird? It may be the pics on conversation, they are just too sn Please and Thank you so much, Sandra 427-268-7614 sandrarathbun94@gmail..com

Read More
Sandra -
November 17, 2014
See more answers
Q:

oven will not work

A:

The control panel does seem the obvious culprit, but the expert will review and respond. If parts are needed, I attached the link to Sears Parts Direct for this model below. I hope this helps if needed.

Read More
Barbara H. -
June 23, 2012
A:

If the elements work then there is power and I suspect the cause of this problem is a bad control. The 316557230 controller is available from the following link: Controller for Kenmore Range . There is also an overlay which you may need: Overlay for Control .

Read More
Fred M -
Sears Technician
June 27, 2012
See more answers

Top Parts