Model #79075852301 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Burners won't lite 79075852301 Kenmore Gas range

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your range and I do understand your frustration. Glad to help out. I'm looking at your model number 79075852301 and from your description I suspect that the spark module has failed. Here is a link that may help further in your troubleshooting. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
November 07, 2014
Q:

Kenmore oven model # 79075852301 will not heat up past 150 degrees

A:

I understand your concern when the Kenmore oven will not heat past 150 degrees. In the link provided below is some great information on a similar issue. Hope this is helpful while and expert responds with additional information on your model.

Read More
Anna T -
December 07, 2012
A:

Thanks for the question about your oven not heating above 150 degrees; I will be glad to assist you.
I presume that the top burners are all working okay and that when the oven comes on the burner has a normal size flame.
Always disconnect power supply before servicing the appliance and when testing live voltage be sure to wear proper safety equipment (gloves and eye protection) also be aware of sharp metals on product
If this is the case then there will be a couple things that can cause this problem. There is a sensor probe inside the oven; you will need to access the back of the oven to test the probe. With the probe isolated from the circuit the ohms reading at room temperature should be about 1050 ohms. If this reading is good then check the wiring harness from the probe to the electronic control for tight connections. If all connections are good then the issue will be in the main oven control.
I hope this helps solve the problem, if you need additional assistance please reply with more details and I will be happy to respond.

Thanks Ron H.
If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Ron H -
Sears Technician
December 08, 2012
See more answers
Q:

How can I get my oven door lock to unlock when the door is open?

A:

In order to possibly get the door lock mechanism to fully lock and unlock will require pushing and holding the door light plunger switch in while pressing the Stop/Clear button. Wait for the door latch to fully lock then unlock. Do not release the door light switch plunger until the latch mechanism fully unlocks. If it stops in the full locked position, hold the door switch plunger in and then press the Stop/Clear button again. Wait for the lock mechanism to fully unlock before releasing the door switch.

Read More
Joey S -
Sears Technician

Top Parts