Model #79075752102 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

79075752102

A:

ManageMyLfe.com is a great place to find your owner's manual and installation guides for appliances. I did some research and found the Installation guide. I have attached the link below. Your expert will follow up and verify this information shortly. If you are having a specific problem please submit your question on the existing tread by click on the reply box below for your expert.?

Read More
Priscilla V -
November 01, 2011
A:

I verified that the manual that Pvalde2 posted in the above response if the correct installation guide for that range. Here is a link for that manual that may be easier to open and read: Installation Instructions . If you need more help, let us know.

Read More
Lyle W -
Sears Technician
November 02, 2011
See more answers
Q:

Gas range natural gas pressure

A:

I know this type of information can be very helpful for you to have.�While you are waiting for your expert answer, I did some research on the unit.�I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information.�Thank you for using Manage My Life.

Read More
Joseph P. -
October 31, 2011
A:

This range requires 4" of natural gas pressure. The complete installation requirements for the gas supply are shown in the image below. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
November 01, 2011
See more answers
Q:

Why did the igniter go bad on my Kenmore gas range model 790.75752102 after only 6 months?

A:

Your symptoms do point to a failed igniter again. The igniters normally last for many years without failing. If you installed the igniter yourself, unplug the range and check the wire connections. Make sure that the ceramic wire nuts are tight. This ignition system depends on the proper current flowing through the circuit. Improper wire connections could cause high resistance in the circuit that would prevent the oven gas valve from opening properly. If the wire connections are secure then you will likely need to replace the igniter again. Be sure that you handle the new igniter with reasonable care. Do not touch the igniter element with your bare finger. This can cause premature failure of the igniter. Make sure that the igniter is installed properly on the burner. Since you are having these problems, I recommend that you have a service technician check the present igniter and replace it if necessary. The technician can measure the amp draw through the circuit with a clamp-on ammeter and can also look for other problems that may be keeping the oven burner from igniting properly. Here is a link for the Sears Service website Sears Home Services .

Read More
Lyle W -
Sears Technician
January 27, 2010

Top Parts