Model #79075748991 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Why is my Kenmore oven not working?

A:

It is great your son is handy with appliances and can help. The expert will review and respond in 24-48 hours if not sooner, so you should have an answer by Sunday. I did research and found a similar question and attached the expert answer for that question. The model is a bit different but it may help. I also added the schematics from Sears Parts Direct for your oven if he needs them. Hope this helps.

Read More
Barbara H. -
March 18, 2011
A:

Here is a video that shows the basic procedure for replacing the control board in this type of range: Range Clock Control Replacement

Your range is slightly different than the one shown in the video but the basic procedure is the same.

Be sure that you unplug the range before accessing internal components.

If you need more help, reply with additional details and we will assist you further.

NOTE: Since neither the bake or broil burners work, it is likely that the control board is bad. If you replace the control board and still have the same problem, you could have a problem with the igniters, the gas valve, the wiring or the temperature sensor.

Read More
Lyle W -
Sears Technician
March 19, 2011
See more answers
Q:

How do I remove the wire cage over my oven bulb and replace?

A:

You will need to push the center of the wire retainer to either side of the lens. It may require moderate force in order for it to pivot clear of the lens. See image below.

Read More
Joey S -
Sears Technician
October 09, 2009
Q:

My oven won't lite unless I first turn on a top burner. What can cause this?

A:

This problem can be caused by the ignitor, the gas valve, or the regulator. If the broil burner will light without turning on a top burner the problem is caused by the ignitor. The oven burners use the same regulator and gas valve.

The way to test the oven ignitor is to read the amp draw of the ignitor. It should slowly rise to 3.2-3.6 amps as it heats.

Read More
Jimmy K -
Sears Technician
October 03, 2008

Top Parts