Model #7907482190 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Cooktop Section
    3 Results
  • Oven Door
    3 Results
  • Broiler Section
    3 Results
  • Body Section
    3 Results
  • Oven Burner And Top Burners Section
    3 Results
Find part by diagram >

Question and Answers

Q:

My Kenmore gas range #7907482190 oven is not working. The ignitor lights fine, but no gas comes into the oven through the safety valve.

A:

Proper gas flow is imperative to have to assure the proper heat for your baked goods, and I am sorry for the inconvenience this has caused you. I am adding two links below to help you with your range problem. I hope this helps while you wait for your expert response.

Read More
Joseph P. -
February 16, 2012
A:

Since the ignitor is glowing red, we know the oven thermostat is working properly.

To properly test the ignitor, you need to read the amps the ignitor draws. The ignitor will (or should) increase in amp draw as it heats up. When the amp draw of the ignitor reaches 3.4-3.6 the gas valve should open. This should happen within 40 seconds from when the oven is turned on.

If the amp draw doesn't reach 3.4 the ignitor is bad.

Since the circuit only consists of the oven thermostat (which we know is working), the oven gas valve (which is new but could still be bad) and the ignitor, you can figure the ignitor has to be the problem. I would test the amp draw of the ignitor to be sure.

The part number of the oven ignitor, if you need it, is 5303935066, and the cost is $63.79. You can order the ignitor at Parts Direct

Read More
Jimmy K -
Sears Technician
February 17, 2012
See more answers
Q:

Kenmore gas range heats to 200 then to 500 degrees is it a thermostat that is out?

A:

You need to replace the thermostat on your range. The part number is 5303210474 and the cost is around $125.00.

Read More
Jimmy K -
Sears Technician
April 04, 2008

Top Parts