Model #79072313011 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

LP gas conveersion

A:

You can visit the Parts Direct website to purchase the manual for the conversion of your range. If you experience any problems you can speak or chat with an associate that will be more than happy to assist you with your search. I have provided the link below. I hope this helps! http://www.searspartsdirect.com/partsdirect/index.action

Read More
Jacqueline S -
October 28, 2010
A:

NOTE: This conversion should be completed by a qualified installer.

The conversion kit normally comes with instructions included. I assume that the full model number for your range is 790.72313010 or 790.72313011. The conversion kit for that range is part number 316542418. I don't have the exact instruction sheet for that conversion kit. I have the sizes for the LP orifices that should be installed on the burners. Here are the orifice sizes:

  • Right front -- 1.18

  • Right rear -- .66

  • Left rear -- 1.09

  • Left front -- .93

  • Center -- .93

I have a copy of the instructions for a similar conversion kit that has different orifice sizes but should be the same except for that. The images below show that information. The installer should be able to use this information to properly convert the range to LP. If you need more help, reply with additional details and we will assist you further.

NOTE: I have contacted the manufacturer and I am trying to obtain a copy of the exact instructions for this conversion kit. If I obtain those instructions, I will update this thread.

If you need an installer to complete this conversion, you can visit the ServiceLive.com website. They have qualified installers in most areas that can convert this range for you. Here is a link for that website: ServiceLive.com

Read More
Lyle W -
Sears Technician
October 29, 2010
A:

ok sounds good what about the oven are the adjustible and if so how do you adjust them thanks for you help

Read More
WILL -
October 29, 2010
A:

The orifice spuds on the oven need to be tightened down until they bottom out. There was a problem with the images of the directions for the similar LP conversion kit appearing in my previous response. Here are the pages from the similar conversion kit that I do have. This should be the same procedure for adjusting the oven (and the regulator) on your range.

Read More
Lyle W -
Sears Technician
October 31, 2010
A:

Here is the 4th page of the LP conversion kit instructions.

Read More
Lyle W -
Sears Technician
October 31, 2010
A:

I just received the exact LP conversion kit instructions for part 316542418. They are provided in the images below.

Read More
Lyle W -
Sears Technician
November 02, 2010
A:

Here is the final page. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
November 02, 2010
See more answers

Top Parts