Model #79071549601 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

No power to stove

A:

A range is a important appliance in a home, when it stops working it can be a big inconvenience. I have attached a link below to manage my life that can of assistance to you while you wait for a experts response. Hope it helps!

Read More
Maira E -
October 15, 2010
A:

If you have no power to the stove but the wall receptacle has power, the electrical cord on the range probably has a problem.

The answer Maira E sent has good information for checking the range.

Be sure to disconnect the range from the wall outlet before removing any panels.

If the clock is not operating and the burners won't spark, the range cord is probably broken or the connections inside the back of the range are broken.

If you are not comfortable making the tests, go to www.searshomeservices.com&MML=MMLxexpertxmerch and schedule service for a Sears technician to diagnose and repair the problem.

Read More
Jimmy K -
Sears Technician
October 16, 2010
See more answers
Q:

Control panel on gas range Model 790.71549601 does not light up. There is power to the outlet. Is there a fuse in the stove or do I need a part?

A:

I added a couple of images below of the wiring schematic and the wiring diagram. There is not fuse in the range and you will not likely need any part other than maybe a new power cord if voltage is not present at the ends of the power cord where it connects to the main harness. Based on your symptom the power cord is likely bad or there is a loose or bad connection where the power cord connects to the main wire harness. First, unplug the range and plug a hair dryer in to see if it will run and heat. If the hair dryer runs and heats then you likely have the proper voltage at the wall receptacle. The range is likely dead because of a bad connection in the power cord or where the power cord attaches to the main harness in the range. You can disconnect the power cord from the outlet and then remove the panel from behind the console. Follow the power cord and it should lead you to the two quick disconnect plugs. Disconnect and reconnect the quick disconnects and then plug the range in and see if you have any display. If the range is still dead then you will need to check and confirm the voltage supply at the two quick disconnect connections for voltage. NOTE: I do not recommend checking voltages unless you have experience and feel safe and confident in doing so otherwise I recommend calling a service technician to diagnose and repair your range. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
April 29, 2010

Top Parts