Model #79071523402 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

What replacement part do I need for my gas oven that is not working, but the stove top works fine?

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina -
November 02, 2012
A:

Kenmore model #790.71523402 Serial # VF51137209

Read More
Jeaneane -
November 02, 2012
A:

Thank you for your question and I understand your concern.

The clock/oven control must power up and it must be working properly or the oven will not operate. If the range is getting the proper voltage and the clock/oven control is blank/dead, the electronic oven control has likely failed and will likely need to be replaced. The electronic oven control #316455410 can be ordered from Sears Parts Direct and you will also need a new clock overlay #316220712 . The electronic oven control can be accessed and replaced from behind the control panel. NOTE: Disconnect the power cord from the power source before removing the panel from behind the control panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
November 03, 2012
See more answers
Q:

Why does the hot air from my 2005 Kenmore oven blow out of a small vent located over the gas range and just below the clock and settings console?

A:

I understand the concern with the steam escaping from the vent under the control board. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Yadira B -
October 25, 2012
A:

Hot air will escape from that vent as the oven initially heats up. That vent allows expanding hot air to escape the oven cavity so that pressure does not build up inside the oven cavity. Once the oven is heated up to the set temperature, less air will flow out of that vent. There will still be some hot air flow out of the vent even after the oven is heated to the set temperature. There is no way to stop that air flow out of the vent. If the oven is working properly then what you are describing is normal.

If you suspect that an abnormal amount of air is flowing out of that vent, then you can have a service technician examine the range. Here is a link for the Sears Service website: Sears Home Services .

If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
October 26, 2012
See more answers
Q:

Kenmore gas range model #79071523402 displaying error code E1?

A:

I do not find an E1 error code on this model of Kenmore range. I do see an F1 error code. F1 usually indicates a defective EOC (clock). Please see the image provided below from the service manual explaining the F1 error coded & recommended action. EOC 316455410, probe 316233902 www.searspartsdirect.com

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
biker dave -
Sears Technician
May 12, 2010

Top Parts