Model #79071342701 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Gas Range Error Code

A:

Error codes do raise concerns. The expert will review your model and provide the best information possible. I did locate a similar question that may help. I attached to the link below along with the Sears Home Services link if a technician is needed. I hope this information helps.

Read More
Barbara -
November 17, 2012
A:

That F10 code indicates that the control detects a runaway temperature (out of range high temperature). This could be caused by a bad oven temperature sensor probe, a wire harness problem or a failed electronic oven clock control board.

If you want to fix this problem yourself, you can unplug the range and check the resistance of the oven temperature sensor probe circuit from the back of the electronic oven clock control board in the console. Remove the back panel behind the console to access that area. The wiring diagram for your range is shown in the image below with that sensor circuit traced in purple. You can pull the connector with the purple wires off of the control board and measure the resistance through that circuit using a volt/ohm meter. You should measure around 1100 ohms at room temperature. If that resistance is more than 200 ohms higher or lower than 1100 ohms, then you will need to check the resistance directly at the sensor probe itself. Remove the lower back panel to access that component (with the range still unplugged ). If that resistance directly at the sensor is bad, then that sensor will need to be replaced. That part number for the sensor is 316490000.

If the resistance of the sensor is okay, then you have a problem with the wire harness between the sensor probe and the electronic clock control board is that resistance measured directly at the control board is higher or lower than 1100 ohms.

If that sensor circuit resistance measured at the control board is okay, then you will probably need to replace that control board (part 316557107). You will normally need to replace the overlay as well if you replace that control board component.

Note: There is a chance that the sensor resistance is okay at room temperature but that it increases abnormally once it is heated up. If you replace the control board and still have problems, then you will need to replace that sensor probe as well.

You can order parts from this page: Kenmore Range Model 790.71342701 Parts . Be sure that you unplug the range before accessing internal components and replacing parts.

If you need more help, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 19, 2012
See more answers
Q:

how can i remove the switch panel of the kenmore range, model # 790.71342701

A:

Definitely having to do repairs on your Range yourself can be a challenge. While you are waiting for a detailed reply from an expert I have taken the time to research on the website and have came across a few links that are similar to your issue,which is you like I have attached below. Hope the is helpful!

Read More
Priscilla V -
February 20, 2012
A:

You will need to remove the cooktop from the range. I am sending some images showing how to do that.

You will also remove the panel that covers the burner valves and switches. Remove the burner knobs. Remove the screws from the bottom of the burner valve panel. When you get the cooktop removed, remove the screws holding the top of the burner valve panel.

If you have questions, reply on this thread and I will be glad to help.

Read More
Jimmy K -
Sears Technician
February 21, 2012
See more answers

Top Parts