Model #79071212703 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I get a conversion kit for my gas range?

A:

According to the installation instructions the LP kit should be found on the back side of the range. Not all models have the kit. You can order the surface burner LP conversion kit at www.sears.com part number 316243701.

Read More
biker dave -
Sears Technician
April 08, 2009
A:

I need to convert a Kenmore 141.16672. I purchased a conversion kit, 10478. Is this the right kit? Can this grill be converted from propane to natural gas?

Read More
Jonathan -
August 26, 2012
A:

I just installed a conversion kit on a Kenmore Freestanding Gas range 709.7090 and the directions were totally wrong so becareful.

Read More
rudster69 -
October 10, 2013
A:

Yes it should have but they are known to disappear especially if you bought it from Sears Outlet stores

Read More
rudster69 -
October 10, 2013
A:

www.sears.com

Read More
rudster69 -
October 10, 2013
See more answers
Q:

How do I remove the drawer in my Kenmore range model 790.71212703 to convert it to LP gas?

A:

LP gas conversions should be completed by a certified installer. The instructions in the conversion kit provide an illustrated procedure to remove a warmer drawer. This conversion kit covers several different models. Your particular model has a broiler drawer. The installer may not need to remove this broiler drawer to convert the range. If it does need to be removed, it appears to have different glides than the warmer drawer. I recommend calling an installer to convert this gas range to LP.

Read More
Lyle W -
Sears Technician
Q:

How do I adjust the oven flame in my new Kenmore range model 790.71212703?

A:

The conversion to LP gas must be performed by a qualified installer. The spud may not turn a full 2 1/2 turns. This is normal. The spud should not be overtightened. You may need to loosen the spud and then tighten it back down to a point where it is snug. The air shutter must also be adjusted according to the LP conversion kit installation instructions. I provided the instructions on the air shutter adjustment in the image below. If you have any doubt about the proper conversion of this range to LP gas, I recommend calling a technician to check the range.

Read More
Lyle W -
Sears Technician

Top Parts