Model #79071052405 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

stove appliance problem

A:

I am assuming that your top burners are working. I've provided a link below that will give you some ideas as to what the issue might be. The model number is not exact but they are very close. If you need instructions on how to replace anything (igniter bar) simply type in the task you wish to do in the upper right corner of this page and you will receive multiple links you can review. You will still receive an expert response from our team in a day or two. Until then, have a nice morning.

Read More
Henry -
September 18, 2012
A:

Make sure that the range has electrical power. The oven will not work if it does not have power.

Check to see if the igniter is glowing when the oven is set in the bake mode. Here is a video that explains the ignition system for your oven. If that igniter is glowing but the burner will not light, then I recommend that you check the service shut-off valve on your regulator. If that gas supply is turned on for the oven, then you will probably need to replace that igniter even though it is glowing. It is likely too weak to allow enough current through the circuit to the safety gas valve as explained in that video.

If the igniter is not glowing then you could have a bad thermostat or a failed igniter. If you need help with diagnosing this type of failure, reply with additional details.

You can order parts from this page: Kenmore Gas Range Model 790.71052405 Parts . Be sure that you unplug the range before accessing internal components.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 19, 2012
See more answers
Q:

kenmore stove # 79071052405

A:

Wanting to convert your Stove from gas to propane can be challenge without any instructions. While you are waiting on an expert to answer your question, I found some great links in the Manage My Life website. I have attached the link below. Have a nice day!

Read More
Dezeray S -
April 18, 2012
A:

I apologize for the trouble that you had in getting your answer to this question. I provided the LP conversion instructions for this range in the images below. The third page shows the procedure for converting the range back to natural gas.

NOTE: That natural gas conversion should be completed by a qualified installer.

If the original owner saved those natural gas orifices for the surface burners, then this conversion may be easier for the installer to complete. If those original orifices are not available, then new 8000 BTU natural gas orfices will need to be installed on those burners. A gas technician should be able to supply those orifices. You can contact your local gas supplier for a qualified installer. You may also be able to find a pre-screened service provider that can complete that conversion on this website: ServiceLive.com .

These tips should help you complete that natural gas conversion. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
April 19, 2012
See more answers

Top Parts