Model #79060712900 KENMORE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

replacing range oven igniter 79060712900 Kenmore Gas range

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore range.

From the information you have provided above, the connecter should just pull right off. I have located some information you might find helpful on replacing the ignition in your Kenmore range. Click here.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
January 28, 2015
A:

Thanks for your help, but I'm not absolutely clear on this. Your replacement part (#316489402) has TWO different connectors, both of which are needed in my oven. I have already disconnected the white plastic 'clip-on' connector. My question is about the OTHER connectors, with flat metallic ends. Do these just pull out of the ceramic base. ( I think similar ends (covered in black tubing) are shown in the first video in your recommended list - at 1:13-1:26, and again at 5:25-5:28,; but in the video these are not part of the repair - he only changes the white plastic clip connector. ) In my case, these metallic connectors are located inside the oven at the bottom center. As soon as I know how to handle the metallic connectors I can order the part, and be back in business. Thanks.

Read More
Bryan -
January 29, 2015
See more answers
Q:

Where are the orifices located on my range and how do I convert it from natural gas to liquid propane?

A:

Fuel conversions are fairly common today as consumers try to save on energy costs. While you wait for the expert review and response, you can check the links below for additional help. The first link has both the installation and product manuals. The second link has the schematics and parts list for this model. You can check for a conversion kit. Hope this information helps with some of your questions.

Read More
Barbara H. -
May 12, 2011
A:

Thank you for your question and I understand your concern.

I was not able to locate the LP conversion kit installation instructions at this time. Your range will likely have the LP kit and instructions located on the back of the range or it one of the envelopes that came with the range.

The instructions will come with the LP kit. If the LP kit did not come supplied with your range then you will need to order it. The part number of the LP kit is 316243723.

I added an image below with some help information however I was not able to locate the LP conversion instructions. I recommend following the instructions that come with kit.

The kit comes with 4 burner valve orifices. The Natural gas orifices will have to be removed by holding the surface burner valve from possibly turning while un-threading the orifices from each burner valve.

You will need to raise the top to access the burner valves. Remove the Natural gas orifices and replace them with the LP orifices. To convert the bake burner to LP, remove the floor of the oven and the flame spreader. There is an adjustable burner spud/orifice on the gas valve that meters the gas flow into the burner tube. The orifice/burner spud should be tightened down until it bottoms out for LP gas. You will also need to adjust the air shutter located directly above the orifice hood/burner spud in order to get the bluest flame.

I recommend having the LP gas supplier convert you range to LP.

Read More
Joey S -
Sears Technician
May 14, 2011
See more answers

Top Parts