Model #79048839900 KENMORE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Need oven dimensions for mounting in a cabinet 79048839900 Kenmore Walloven

A:

I understand the need for having the dimensions for the wall oven. I found some information for you that Ia m hoping will help you. I am adding the link below to help you with your question while you wait for your expert response. It may take 24-48 hours. I do hope that this will help you out.

Read More
Marc -
November 25, 2012
A:

Thanks Marc, but no link was added.

Read More
Tim -
November 25, 2012
A:

I can understand how important it is to have the right information for your wall oven. The image below will provide the dimensions for this model, as well as the cut out for the cabinet. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
November 26, 2012
See more answers
Q:

Oven will not work after clean cycle. Is there a fuse and where is it, if so?

A:

I understand that your oven will not work work after the clean cycle. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
March 31, 2012
A:

There is a thermal circuit breaker on the outside back wall of the oven cavity. You would need to shut off the house circuit breakers for the oven and pull it out of the cabinet to access that component. Remove the outer back panel to access the back of the oven cavity and find that thermal circuit breaker. That component should look like the one shown in the image below. It will have a red button that you can press to reset the component. After resetting that thermal circuit breaker, reassemble the oven and see if it will heat.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
April 02, 2012
See more answers
Q:

Oven not working

A:

Oven problems can be very upsetting specially when cooking dinner. A suggestion I have while you are waiting on an expert to answer your question. You can visit SearsHomeServices.com website to set services with Sears to diagnose your problem. I attached the link below. Hope this helps! Good luck.

Read More
Dezeray S -
October 05, 2010
A:

There is a safety thermostat on the outer back wall of the oven. This thermostat is likely "open". This will prevent the bake and broil elements from heating. Since the oven is under warranty, I recommend that you have a Sears Service Technician fix this type of problem. You can call Sears for service at 1-800-469-4663 (1-800-4MY-HOME).

If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
October 05, 2010
A:

The oven is built-in. How do I access this thermostat on the outer back wall?

Read More
MichaelSimpson -
October 05, 2010
A:

Shut off the breaker to disconnect electrical power to the oven. I provided a link for the installation guide on this model below. You will need to reverse the installation steps to pull the oven out of the cabinet. Remove the bottom trim and the anti-tip screws. Once you get the oven pulled out (and supported properly), you can locate the thermal cut-off on the back of the oven. I believe that this one has a reset button. Push the reset button and then re-install the oven. See if it heats properly. If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
October 05, 2010
See more answers

Top Parts